laser head with air pressure and smoke extract
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
laser head for atomstack a5 m50 pro
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 78
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Assembly for the head of the laser engraver. You will need TPU plastic or silicone for sealing, 4 screws m3x8, a quick-release connector for a hose with a diameter of 4mm. air hose 4mmx2mm length 2m, air compressor. something for drawing air (I made a homemade mini turbine for this), as a hose for removing smoke I used a flexible cable channel with an outer diameter of 25mm (keep in mind this is not a good option because it can create a strong whistle, use a turbine with speed control I took a turbine from Aliexpress for 12v, my normal operating mode was at a voltage of 7v and consumption of 1.5A.) You also need to put some spacers or on the ends because the sizes are tight. I replaced the standard buttons with KW4-3Z-3 (L15)
I recommend for assembly, high efficiency of smoke absorption.