Slinky_V17
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Big Slinky, probably capable of walking down the Stairs, but such stairs were not found yet:) Name V17 says a lot:)
- Ocena
- 4,923 / 5
- Polubienia
- 90
- Pobrania
- 1108
- Wydruki
- 19
- Wyświetlenia
- 2961
- Oceny
- 13
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Public Domain
Slinky with diameter of 90mm and height of 100mm and 50 rings. It is very nice, problem is just to separate the rings. Printed with PLA. Try a height of 10mm (Model for height 10mm is also in the attachments ) and try to separate the rings and then you are ready to print a height of 100mm.
Between rings is just 0,25mm of air. Hard to separate but nice to look.
Separation: First use Needle-noise pliers and with movement make place between two rings where you insert Olfa-knife and go with the knife over whole length.
Probably slinky should walk down the stairs, but the stairs were not found yet:) I would say the maximal length of the Stair should be cca 150mm.