Slinky_V17
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Big Slinky, probably capable of walking down the Stairs, but such stairs were not found yet:) Name V17 says a lot:)
- Rating
- 4.923 / 5
- Likes
- 90
- Downloads
- 1,108
- Makes
- 19
- Views
- 2,961
- Reviews
- 13
Updated at source:
Model information
- Source
- Printables
- Category
- Other Toys & Games
- License
- Creative Commons — Public Domain
Slinky with diameter of 90mm and height of 100mm and 50 rings. It is very nice, problem is just to separate the rings. Printed with PLA. Try a height of 10mm (Model for height 10mm is also in the attachments ) and try to separate the rings and then you are ready to print a height of 100mm.
Between rings is just 0,25mm of air. Hard to separate but nice to look.
Separation: First use Needle-noise pliers and with movement make place between two rings where you insert Olfa-knife and go with the knife over whole length.
Probably slinky should walk down the stairs, but the stairs were not found yet:) I would say the maximal length of the Stair should be cca 150mm.