Gridfinity superglue or JT16 Glue stick holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A 1x1 Gridfinity Refined block for holding a superglue bottle or stick of JT16 3D printing glue
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 20
- Wydruki
- 0
- Wyświetlenia
- 102
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Share Alike
A simple 30.5mm diameter hole with a 1mm bevel in a 1x1 Gridfinity Refined block.. suitable for a hole load of uses, but designed to hold a standard superglue bottle or a JT16 glue stick. I kept it a fairly loose fit so there was no chance of it sticking as I removed it- but tight enough so it’s not going to fall over.
I used a full 4 magnets in the base of this one (I usually just use 2) for stability.
Sub-component stuff:
These are the magnets I use for all my gridfinity stuff: https://amzn.to/3DFTKtO.
These are the glue sticks I use, and which fit in this holder: https://amzn.to/45hq2qI
(Note: These are associate links, which means that they don't cost you any more, but I get a small cut if you purchase via these links. This isn't a big money-spinner, but I find it so useful to have sub-components linked in models that I download - so I know I'm getting exactly the right bits without much research, and it helps support my tinkering!).