1 / 3
Sovol SV08 drag chain system - Toolhead fixation
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a remix of relevant parts of the official Drag chain System by @g013u_2076235
- Ocena
- 4 / 5
- Polubienia
- 36
- Pobrania
- 212
- Wydruki
- 1
- Wyświetlenia
- 1282
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
SzczegółyPliki (4)Wydruki i komentarze (Wydruki: 1) (Komentarze: 2)Remiksy (1)Kolekcje (55)Powiązane
I reworked the two parts that are connected to the bowden filament tube on top of the toolhead.
- problems
- the chain is orignally “lose”, its only attached to the bowden tube and the cable
- the filament tube releases itself due to pressure on the quick release ring
- the chain is hanging more bacause its not attached to a fix spot
- solution
- I attached the cable clip that is originally screwed to the toolhead at the drag chain holder
- I added a ring as a guide for the quick release ring
You have to cut a little bit on the upper side of the toolheadcover, but its not much. Just to make the cover fit again.
BOM
M3*10 bolt x1
M3*4 insertnut x1
I printed all the parts out of ABS+ ESUN. Maybe I'm going to reprint everything in ASA-CF or ABS-CF. The prototype you can see in the picture was printed out of transparent PETG for testing.
If you like my rework, please like :)