Eachine EV800 / EV800D button protection
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution
I'm using the bad shipped with the goggles to store them in a bigger bag.
The only issue with it is that it could turn the power on by pressing the button for long enough, due to another item being in the same storage.
I made this very simple object to prevent the buttons from being pressed when stored loosely.
Print Settings
Rafts:
Doesn't Matter
Supports:
Doesn't Matter
Resolution:
designed for 0.8mm nozzle
Infill:
none
Filament:
Noname wood PLA - not too rigid
Notes:
I made my print upside down to have the part touching the goggles as clean as possible, but I guess it doesn't matter so much.
If my tolerances aren't good for you, scale a bit the model to fit your needs, mine was printed at 100% but the first couple of fits were really tight - the wooden PLA used is a big gummy and worked great at slightly deforming - great to not damage the connectors.I recommend >= 2 walls
designed for a 0.8mm nozzle but should do on 0.4 by using more walls or some infill.
Don't use more than 1.8mm nozzle ;)
Category: Parts