[HW-132 Case] - USB Step Up Power Supply Module / Voltage Regulator
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a compact case for the normally barebones Chinese USB step-up power supply / voltage regulator HW-132.
- Ocena
- 5 / 5
- Polubienia
- 68
- Pobrania
- 622
- Wydruki
- 6
- Wyświetlenia
- 2265
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
Two versions are available: with and without screws. The body is made up of two halves, which hold together quite well due to friction - using the screws is recommended, though. Screws required:
2× M2 hex 6 mm (or a bit shorter) (front - near the USB)
2× M2 hex 8 mm (or a bit shorter) (back - near the output)
In case you don't have these screws, print the screwless version! The original product can be purchased here:
Following settings were used to print this file:
Original Prusa MK1
PETG white prusament
0.2 layer height
30-60% speed
240°C/90°C
No supports
No special settings
Note: One of the pieces needs to be rotated 180° to lie on the flat side
If you find this print useful, please share your results with me :)