[HW-132 Case] - USB Step Up Power Supply Module / Voltage Regulator
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a compact case for the normally barebones Chinese USB step-up power supply / voltage regulator HW-132.
- Rating
- 5 / 5
- Likes
- 70
- Downloads
- 633
- Makes
- 6
- Views
- 2,293
- Reviews
- 4
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution
Two versions are available: with and without screws. The body is made up of two halves, which hold together quite well due to friction - using the screws is recommended, though. Screws required:
2× M2 hex 6 mm (or a bit shorter) (front - near the USB)
2× M2 hex 8 mm (or a bit shorter) (back - near the output)
In case you don't have these screws, print the screwless version! The original product can be purchased here:
Following settings were used to print this file:
Original Prusa MK1
PETG white prusament
0.2 layer height
30-60% speed
240°C/90°C
No supports
No special settings
Note: One of the pieces needs to be rotated 180° to lie on the flat side
If you find this print useful, please share your results with me :)