1 / 4
Husky Industrial Duty Steel Shelf Leg Insert Caps — zdjęcie 1
1 / 4

Husky Industrial Duty Steel Shelf Leg Insert Caps

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Caps for the top of the shelf legs. Good for gaining that overall finished look as well as protect from sharp edges

Ocena
5 / 5
Polubienia
3
Pobrania
17
Wydruki
1
Wyświetlenia
89
Oceny
2

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Garage
Licencja
Creative Commons — Public Domain

These setting will make for some very solid caps that, when struck, should resist breakage very well: PETG (or better). 8 walls, 5 top and 5 bottom layers. 75% infill. 

For work, we haul trailers of our climb gear, tools, and equipment around from worksite to worksite. These trailers have Husky (honestly, they may be Gladiator) brand industrial shelving on the two side walls as well as the front. With how frequently people are accessing these shelves for supplies, it quickly became apparent just how sharp the top edges of the legs are. I quickly designed these caps to prevent rushing employees from being injured. While the caps fit snugly in place, there are no locking mechanisms. My first design had locking tabs that reached down to the nearest set of holes in the narrow faces of the legs, but the reach proved too far to be strong enough to resist breaking while simultaneously being flexible enough to squeeze into the tops of the legs. While the final design (the ones here) don't physically “lock” into anything, they fit snugly enough that they don't come back out without deliberately pushing them out.

Now that they're installed, it's virtually impossible to accidentally cut yourself if your hand/arm grazed across the top edges of the shelf legs. An additional benefit is that with the legs capped, the shelves now look much more “finished” than they look without them. I'm sharing them here because I can see where print farmers or anybody else that frequently uses this type of shelving on a regular basis can benefit. Since I was at work when I designed, printed, and installed these caps while simultaneously keeping up with my regular work duties, I've yet to take any pictures of the caps installed that I can share here. I'm sure seeing the designs will make them self explanatory though. You're welcome to share your makes here!

I designed three different types of caps because they're what I needed to suit my needs. One is just your basic cap that'll fit the unmodified shelf leg. One of the shelf legs was cut shorter so an extension ladder could fit on the top shelf (the trailer rear door height necessitated it) and it was cut near the top of the horizontal cross member built into the shelf. You'll see a cap with off-center gussets and a recess. This design allows space for the cap to cover the cross member without being inhibited by it. Another leg has a 10AWG ground wire in it that runs out of the top of it. I placed a 5mm slot in it what's otherwise a basic cap to facilitate the wire's routing.

Tagi