1 / 6
Robin Nano v3 case w/ 40mm fan mount 2020 extrusion — zdjęcie 1
1 / 6

Robin Nano v3 case w/ 40mm fan mount 2020 extrusion

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Robin Nano v3 case w/ 40mm fan mount 2020 extrusion

Ocena
0 / 5
Polubienia
1
Pobrania
19
Wydruki
0
Wyświetlenia
103
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

I wanted a horizontal mount a secondary MCU for Tronxy X5SA Pro build. It needed to be in the front right side so it could be hooked to a display.

Printed in PLA using Voron print specifications. Supports may be required depending on your part cooling.

Models:
There are 5 bottoms models which either have no tabs or will have 40mm long taps in 2 directions.  Additionally, there is one top that will fit any of the bottoms.

Parts:
-4 x 8-12mm M3 screws can be used to fasten the board
-4 x M3x30mm screws through top into bottom
-4 x M3 nuts/locknuts for bottom
-4 to 5 x M5x10mm for tabs
-4 to 5 x hammer nut or equivalent for 2020

Optional Parts:
-40mm fan grill with M3x25mm screws to nylock nuts

**Please note that the 40mm fan will either mount to the top or the bottom with 2 screws.  The top and bottom will then close the gap.

**This could be used vertically depending on use case.
**remixed from:
https://www.printables.com/model/1063039-btt-skr-14-case-w-40mm-fan-mount-2020-extrusion
 

Tagi