EVGA XR1 Lite Wire Shelf Holder/Hook
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
For if you want to hang your XR1 Lite off a wire shelf.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 73
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution
Was redoing my capture setup and figured there must be a better way than letting my XR1 Lite just chill on the ground under my PC. Seeing as my PC sits on a wire shelf, I'm sure I can just jump into Tinkercad and quickly whip something up. And I did!
This allows the XR1 Lite to hang off the side (or back, depending on orientation) of a wire shelf. The hanger gap is 5mm, so keep that in mind (and measure your shelf with calipers since I'm sure not all of these wire shelves are standard)
In my case the XR1 fits snugly with plenty of space for the connectors.
I printed mine out in PLA, 15% infill, rotated on its side (as shown in the photo). If your printer's good at bridging you shouldn't need supports.