1 / 1
Duke Doks ed3 v6 and bmg main piece air flow mod — zdjęcie 1

Duke Doks ed3 v6 and bmg main piece air flow mod

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is an air flow remix of a direct drive mount for the ender 3/5 built by Duke Doks

Ocena
0 / 5
Polubienia
0
Pobrania
22
Wydruki
0
Wyświetlenia
200
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

I really liked the work done on https://www.printables.com/model/447956-e3d-v6volcano-bmg-ender-3-3-pro-3-v2-5-plus

After i printed it off for my ender 3 i noticed that there were less air holes for the heat break than on the previous hot end mods i was using. I am not sure if this is actually needed, but it made me feel a bit more confident about the amount of air coming in vs out.

I might have overdone it and created a problem where there wasnt one. Lower pressure is not good for dust according to pc builders…