1 / 1
Duke Doks ed3 v6 and bmg main piece air flow mod
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is an air flow remix of a direct drive mount for the ender 3/5 built by Duke Doks
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 22
- Makes
- 0
- Views
- 200
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Creality Parts & Upgrades
- License
- Creative Commons — Attribution — Share Alike
I really liked the work done on https://www.printables.com/model/447956-e3d-v6volcano-bmg-ender-3-3-pro-3-v2-5-plus
After i printed it off for my ender 3 i noticed that there were less air holes for the heat break than on the previous hot end mods i was using. I am not sure if this is actually needed, but it made me feel a bit more confident about the amount of air coming in vs out.
I might have overdone it and created a problem where there wasnt one. Lower pressure is not good for dust according to pc builders…