Worx charger wall mount replacement shell
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mount your basic Worx charger to the wall, like how it should probably have been designed in the first place.
- Ocena
- 5 / 5
- Polubienia
- 9
- Pobrania
- 42
- Wydruki
- 1
- Wyświetlenia
- 245
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- BSD License
Want to put your Worx Share Power charger on the wall? Now you can! (If you are brave)
Step 1)
Reflect deeply on not complaining or suing anyone if your charger catches fire and burns your house down.
Step 2)
Remove these screws
Step 3)
Marvel in human ingenuity, try not to break it, set the back part aside in an appropriate location like that kitchen drawer with miscellaneous batteries.
Step 4)
Get a piece of translucent or clear filament, TPU works well. Cut it at 45 degrees
Step 5)
Poke the filament in the bottom hole with the angled face you just cut towards you.
Step 6)
Cut the excess flush with the outside.
Step 7)
Address any injuries sustained in previous steps, re-evaluate life choices.
Screw the new mount onto the charger.
Step 8)
Screw the charger onto the wall.
Step 9)
Slap a battery in and behold the witchcraft of the status light now at the bottom.
STEP files are included if you want to make it a DIN mount or whatever. License is BSD, go wild, sell them on Etsy, get sued by Worx, whatever you want.