Cupra Born Magsafe retrofit
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Cupra Born Magsafe retrofit using Anker MagGo qi2 charger
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 56
- Wydruki
- 0
- Wyświetlenia
- 743
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
Print face down with normal supports, I used PETG but ABS/ASA would be better for hotter climates.
Should work with any iPhone model as I have tested with a 15 Pro Max, camera bump isnt an issue either with the charging pad being raised.
I used this charger https://amzn.eu/d/6cqbcXs as it was cheaper than the official magsafe charger, no point in using anything fancy as the USB C ports on the Born are only 7.5w.
I used 3m tape to hold the charger in for a bit of extra holding power for stronger magnetic cases.
I included the blank without the charger so you can remix this however you like :)
I plan to make a surround so you can cover over the holes where the stock rubber mat is but haven't gotten around to it yet.
Tested with a 2025 Cupra Born without wireless charger upgrade, Id assume its the same for all cars but results may vary.