Cupra Born Magsafe retrofit
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Cupra Born Magsafe retrofit using Anker MagGo qi2 charger
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 56
- Makes
- 0
- Views
- 743
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Automotive
- License
- Creative Commons — Attribution — Noncommercial
Print face down with normal supports, I used PETG but ABS/ASA would be better for hotter climates.
Should work with any iPhone model as I have tested with a 15 Pro Max, camera bump isnt an issue either with the charging pad being raised.
I used this charger https://amzn.eu/d/6cqbcXs as it was cheaper than the official magsafe charger, no point in using anything fancy as the USB C ports on the Born are only 7.5w.
I used 3m tape to hold the charger in for a bit of extra holding power for stronger magnetic cases.
I included the blank without the charger so you can remix this however you like :)
I plan to make a surround so you can cover over the holes where the stock rubber mat is but haven't gotten around to it yet.
Tested with a 2025 Cupra Born without wireless charger upgrade, Id assume its the same for all cars but results may vary.