Konig Torch Wheel Center Caps - blanks

This is more just for design reference rather than to be used. The odds of somebody else having these wheels with the exact bore profile, let alone with this level of wear, are slim to none.

A good two years ago, the original caps on one of my wheels disappeared. The wheels are fairly old by now (11 years), so the pitting/etc over time made the bore a bit too loose for them (or it's possible I didn't check if it was actually snapped in, either way it's gone). These have been made for a while now. I use ASA as the material. PETG might work with the snap design, but it being less forgiving flex-wise might not work too well.

Since new wheels are costly, and these are still in good shape (although in dire need of a refurbishing visually) I decided to just print some new caps, and slap my logo on it because why not.

The design is extremely similar and almost 1:1 to the original caps. I had to enlarge the bore fitment and the snap fit a little bit to compensate for the wear, as well as make a few changes so that it was a printable design. I haven't uploaded the files with my logo, but I did upload blank files to play with (.STEP and .STL) for anybody to use as a reference to make their own for their wheels.
 

The snap ring has a small air gap beneath it so that it's printable (I reduced the gap from the original design for this). It essentially just uses the model itself as a support for the curved bridge and prints fairly well for me.

The holes are sized for M3 x 6mm bolts. Stainless would be recommended, as all the black oxide bolts I've used have rusted up essentially.