Garden Sprinklers in a row

Please print these in ABS or other filament that does not deteriorate when left outside.  Print with supports (I use tree slim supports).

To put these together you need some screws and washers.  I just found some random screws and washers in my tool box.  The screws should be about 2 inches long.  Place the washer in between the Top and bottom pieces then put the screw in, leaving enough room that the top can freely spin.  You can screw the base to a board, or other material to help it lay flat.  I did not need to do this where I am using them.  Then I took a garden hose repair kit from Amazon, cut my hose into appropriate lengths and used the garden hose repair kit to ‘repair’ the hose pieces so that I can attach them to the sprinklers.  Last of all, I put a hose end cap on the final sprinkler head before I put the assembly in my garden bed.  It works well for my long garden and I no long heave to go move the hose 5 or 6 times to water the whole garden.  Be sure to use a washer and Teflon tape in each connection to prevent leaks.