M100 GPS + Antennas holder for Source V5
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A Simple LIGHT model to hold your 20X20 M100 GPS and antennas.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 27
- Wydruki
- 0
- Wyświetlenia
- 95
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial
A simple light GPS mount option for the source one V5 Frame, since most I could find were either too heavy (racer brain) or didn't have enough tilt (like seriously who cruises at 30 degrees?).
Uses your standard two screw SMA mount, I used 2 m2x7 screws with nuts to hold it in place, it's also extra beefy in that area to hopefully mitigate antenna vibration. You may have to cut out the antenna slot at the bottom, I keep it intentionally tight so that it prints better. I'll also Include 2 versions, the standard and cutout bottom, incase your vtx doesn't like to play nice and fit within the lines.
Use TPU, just your standard “95A” the softer the better though. 100% infill, tree supports on.
Here's a pic of the print orientation I used:
