1 / 2
Sony a6600 Grip Extension with AirTag Slot — zdjęcie 1
1 / 2

Sony a6600 Grip Extension with AirTag Slot

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A remix of a Sony a6600 camera grip extension with AirTag storage.

Ocena
0 / 5
Polubienia
1
Pobrania
28
Wydruki
0
Wyświetlenia
312
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Photo & Video
Licencja
Creative Commons — Attribution

This is a slim grip extension for a Sony a6600 camera. It holds a single AirTag under the battery compartment. The AirTag on the non-door model is held-in by gravity and there is no clip or cover holding it in. The hinged door model has a a small clip on the right-hand-side to help keep the AirTag in and a small notch on the left to help remove the AirTag.

The original hinged model says to use 8x3mm magnets. In my experience, there is not nearly enough clearance to use that thick of a magnet. I tried using a magnet and a cut-down Zinc washer and the hinge still doesn't close all the way. I'm going to try with some smaller 2mm and 1mm thick magnets on the next print.

The printed example was made with a 0.6mm nozzle at 0.3mm layer height with Prusa JET Black PETG. I printed with paint-on supports for the camera screw-hole.

Tagi