Sony a6600 Grip Extension with AirTag Slot
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A remix of a Sony a6600 camera grip extension with AirTag storage.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 28
- Makes
- 0
- Views
- 312
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Photo & Video
- License
- Creative Commons — Attribution
This is a slim grip extension for a Sony a6600 camera. It holds a single AirTag under the battery compartment. The AirTag on the non-door model is held-in by gravity and there is no clip or cover holding it in. The hinged door model has a a small clip on the right-hand-side to help keep the AirTag in and a small notch on the left to help remove the AirTag.
The original hinged model says to use 8x3mm magnets. In my experience, there is not nearly enough clearance to use that thick of a magnet. I tried using a magnet and a cut-down Zinc washer and the hinge still doesn't close all the way. I'm going to try with some smaller 2mm and 1mm thick magnets on the next print.
The printed example was made with a 0.6mm nozzle at 0.3mm layer height with Prusa JET Black PETG. I printed with paint-on supports for the camera screw-hole.