K1 Max CFS w/ Orca Config & Test Print 7/9/25 Update
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Allow K1 Max to work with Orca after the upgrade w/ Orca Slicer and automatic filament swaps! Read Description update!
- Ocena
- 5 / 5
- Polubienia
- 89
- Pobrania
- 1716
- Wydruki
- 2
- Wyświetlenia
- 4526
- Oceny
- 5
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution
Update 7/9/25- I am uploading a new file for this as the Y coordinates changes when adding the CFS upgrade kit. The new Print Volume is 300x295x300 as per Creality Wiki. I discovered this issue when trying to print my Z offset test and I kept getting Y coordinate out of bounds error message.
Update: 6/10/25 New file has been uploaded as user Seastone Stu edited the gcode to now allow the Upload and Print feature in Orca to work. If you see him around, give him a thank you!
UPDATE: 6/2/25 I created a .3mf file specifically for the the smaller K1 machines which can be found here: https://www.printables.com/model/1316504-k1k1ck1se-cfs-upgrade-orca-slicer-config-test
UPDATE: 5/28/25 I was having an issue where the printer would not put the model sliced in the center of the bed. I found a missed step in this that I am correcting now. If you dont want to download the new file, go to your Printer and Set the Printable Area to whatever your Printer is (K1 max is 300x300). I did not change this value before I posted this. The new file has been corrected and the old file has been removed. Sorry about that!
Was having issues getting Orcaslicer to work nicely with the K1 Max after the upgrade kit installation. I was able to get it to talk to the printer, and get the initial filament loaded but any swaps were done manually. A user on reddit named “Gramps-too” had posted a link to the K2 wiki for using Orca slicer and I was able to adapt that to the K1 Max. I edited the X Y & Z parameters since the K2 is larger than the K1 Max. You could easily adapt this to the smaller K1, K1C, and K1SE easily by edit those values as well.
I also included a quick 1 layer high test print to check your printer and CFS will work properly. Once you are satisfied Id suggest saving the printer with a new name and transferring all the values for this new profile.