1 / 4
The "Kestrel" // An (almost) fully 3D printable foam dart Stringer Blaster
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
My first foam dart blaster design
- Ocena
- 5 / 5
- Polubienia
- 23
- Pobrania
- 46
- Wydruki
- 0
- Wyświetlenia
- 722
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Toys
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (5)Wydruki i komentarze (Wydruki: 0) (Komentarze: 8)Remiksy (1)Kolekcje (10)Powiązane
This is the “Kestrel”, My first foam dart blaster design!
If you have any feedback or find any problems, please let me know!
The top loading system is back, now with all the issues cleaned up!
PRINT THE END OF THE BARREL IN ORANGE!!! (As shown in images)
You will need some 4-5mm bungee cord (I used 4mm)
Print instructions
Print the main body of the blaster vertically with the front end of the barrel on the plate
The slide can be printed in any orientation EXCEPT vertically with the handle facing upwards
The pin should be printed vertically
Assembly instructions:
- Insert the trigger into the hole above the trigger guard (it may also fit in the hole at the back of the blaster, but i haven't tested that yet)
- Push the pin into its hole, lining the trigger up with it (If the pin gets stuck in the middle DO NOT FORCE IT! Move the trigger around until the pin goes through)
- Put on the priming slide
- Slip a piece of bungee cord through the slits in the side of the blaster, thread the two ends through the holes on either side of the front, and tie them together. The blaster gets all of its power from the cord being as tight as possible, so tighten it as much as you can!
These designs take a lot of time and filament (I had to make 6 prototypes!) to make, so liking the model if you like my design would be very appreciated!