Mazda B2200 pickup shackle spacers for lowered springs
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Shackle spacers to fit a stock length T-100 pickup shackle for use on a Mazda B2200 pickup using the Belltech lowering…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 79
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Shackle spacers to fit a stock length T-100 pickup shackle for use on a Mazda B2200 pickup using the Belltech lowering springs. These springs are longer than the stock Mazda springs and thus cause the spring shackle to contact the frame.
Using a 1" longer than stock shackle (4.5" vs. 3.5") prevents the shackle from rotating back so far. Stock Toyota T100 spring shackles, pictured in photo 1: https://amzn.to/3STn5Fp
Dimensions: https://www.4crawler.com/4x4/ForSale/Shackles.shtml#FAQ10
T100 upper width is 113mm, Mazda is 88mm, difference 25mm, split into 2 - 12.5mm spacers placed on either side of the upper shackle hanger bushing will make up that difference. You'll need 4 spacers in all, 2 per shackle on top.
These spacers provide a way to use an inexpensive set of stock Toyota T100 spring shackles on a lowered Mazda B2200 pickup. Combine these shackles with a set of lowering/relocation blocks:
https://www.printables.com/model/1179160-leaf-spring-relocation-plate-or-liftlowering-block
Several options for making these:
- Print in a flexible filament like TPU, it will act like part of the spring eye bushing.
- Or, use 3/4" washers to fill in the gap on each side as well
- Or cut spacers out of 1/2" plastic/metal sheet or plastic/metal rod stock, as pictured in the 2nd photo.
These spacers can be used on other spring shackles. For example to make a "wide body" shackle, such as can be used on a front spring with through the frame spring hanger on a Toyota pickup or 4Runner. For this, you need approx. 3/4" or 19mm thickness and if you make the spacers out of steel, they can be welded to the shackle side plates if desired. Simply use a hole saw of the desired OD and cut 4 spacers out of 3/4" x 2" bar stock, and drill the ID out to accommodate your shackle bolts, 14mm or 18mm typical.
Category: Automotive
