1 / 4
Lens Hood (37mm thread) and cap
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Lens hood for C-mount 16mm manual lens (37mm thread 0.75mm pitch).
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 54
- Wydruki
- 0
- Wyświetlenia
- 284
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Share Alike
Lens hood for C-mount 16mm manual lens (37mm thread 0.75mm pitch).
- Models include 2 versions (smooth or jagged inside for low-reflective treatment), hood cap, and a rear spacer for use with IMX585 starlighteye module by Will Whang. The viewing angle is designed to be used in this lens-module combination.
- I intended to paint the inside with ultra-low reflective black paint e.g. Black 3.0/4.0 or Musou Black.
- If you want to try fuzzy skin printing, I suggest smooth version only, the jagged version might have droopy teeth if your fuzzy setting is too aggressive.
- The rear spacer is for adjusting back focus to slightly over infinity, and covering up the 2x set screw holes to avoid light leakage.
- I printed hood cap with Bambu Lab TPU for AMS, Shore hardness is roughly 60D. TPU 95A would be too soft and falls off easily.
Designed using TinkerCAD.