LCR-T4 Component Tester Case

I looked for an LCR-T4 case with the following features, but couldn't find one, so I made it myself.

• Built-in battery
• No need to remove screws when replacing the battery
• Battery and screws are hidden
• Access to terminals for measuring surface-mounted components
• Thin cover around the above terminals
• Terminal numbers printed on the circuit board are visible

Parts

Printed parts

• base
• battery_cover
• display_cover
• control_cover
• corner_cover

Non-printed parts

• LCR-T4
• 9V battery
• Four M3x8mm hexagon socket head cap screws

Assembly instructions

1. Insert the screws into the base
   
2. Place the LCR-T4 to match the holes in the PCB and the screws, thread the wiring through the slits, and place the battery in its designated position
   
3. Insert the battery_cover
   
4. Attach the control_cover
   
5. Attach the display_cover and tighten the screws to secure the display_cover and control_cover
   
6. Attach the corner_cover
   

How to remove the battery_cover

Press with your thumb as shown in the photo to remove it.

If the dimensions do not match

Since this was made by matching the actual product, there is a possibility that the dimensions may not match due to product variations or minor changes. In that case, please open the attached f3d file in Autodesk Fusion and make the necessary adjustments.