Runcam Thumb Pro mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A protective drone mount for Thumb Pro action cam
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 19
- Wydruki
- 0
- Wyświetlenia
- 149
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A protective drone mount for the Thumb Pro camera.
I made this mount for the Tinyhawk 2 Freestyle, but the holes are the same as the original mount included by the manufacturer, so I guess it fits more quads. If other hole spacing is needed, please message me.
The original mount didn't feel secure and I had heard cam ejected sometimes in a crash.
I tried to make it as lightweight as I could and providing maximum protection at the same time. It protected my cam well and it survived a lot of hard crashes with no damage nor ejecting the cam from the mount. Finally I lost it along with the drone, so I don't have any photos with the cam installed.
Print instructions:
Print with TPU.
Place the mount on the back.
After printing use a sharp knife to partially cut the lens protector from the case. Leave only two “legs” on the left side to keep it in place but be able to slide the camera in and then slide the lens protector on the lens.