Magnetic, Recessor mount, for HAZOEE - TUYA Multi Sensor (4-in-1)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Magnetic, swifel-mount +-18 degree
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 29
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial
I bought:
The HAZOEE - TUYA Multi Sensor (4-in-1) with "recessor" and broke one :-(
Ordering and shipping a new one is quite expensive
…and of course one can NOT order just a "recessor".
The original, had the magnet mounted (with a screw) from the sensor side,
I placed the magnet on the backside of the carrier and used 2 layers for separation.
The magnet is glued on. (Magnet: OD15x4 with hole)
.. or use any other magnet. You may have to modify the attached Fusion360 file
I always try to create models, that can be printed without support.
Unfortunately the “Sensor carrier” needs a little bit of support, but it comes of easy.
Getting the spring on, is a bit tricky. … but you will figure it out :-)
If you want to use this model, you will need some “Downlight Torsion springs”.
I would use 12-16mm wide springs with ~45mm arms and wire diameter ~1-1.5mm
which can be found here.
(I used the once from the broken mount)
The attached Fusion360 has a parameter, where you can enter the spring-width.
I also increased the OD of the mount to 96mm, so it can cover my existing 79mm ceiling cut-outs easily. ( also covers screw-holes of my previous recess mounts)
Just for info:
0.2mm layer height and 0.4mm nozzle
Bottom fill pattern for the : Octogram Spiral
change to what ever you think is best :-)
Cheers