1 / 11
Magnetic, Recessor mount, for HAZOEE - TUYA Multi Sensor (4-in-1) — image 1
1 / 11

Magnetic, Recessor mount, for HAZOEE - TUYA Multi Sensor (4-in-1)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Magnetic, swifel-mount +-18 degree

Rating
0 / 5
Likes
0
Downloads
5
Makes
0
Views
29
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial

I bought:
The HAZOEE - TUYA Multi Sensor (4-in-1) with "recessor" and broke one :-(

Ordering and shipping a new one is quite expensive
…and of course one can NOT order just a "recessor".

The original, had the magnet mounted (with a screw) from the sensor side,

I placed the magnet on the backside of the carrier and used 2 layers for separation.
The magnet is glued on. (Magnet: OD15x4 with hole)
.. or use any other magnet.  You may have to modify the attached Fusion360 file

I always try to create models, that can be printed without support.
Unfortunately the “Sensor carrier” needs a little bit of support, but it comes of easy.  

Getting the spring on, is a bit tricky.    … but you will figure it out :-)

If you want to use this model, you will need some “Downlight Torsion springs”.
I would use 12-16mm wide springs with ~45mm arms and wire diameter ~1-1.5mm
which can be found here.
(I used the once from the broken mount)
The attached Fusion360 has a parameter, where you can enter the spring-width.

I also increased the OD of the mount to 96mm, so it can cover my existing 79mm ceiling cut-outs easily. ( also covers screw-holes of my previous recess mounts)

 
Just for info:
0.2mm layer height and 0.4mm nozzle
Bottom fill pattern for the : Octogram Spiral
change to what ever you think is best :-)

Cheers
 


 

Tags