1 / 10
Naipo Massager Replacement Ball — zdjęcie 1
1 / 10

Naipo Massager Replacement Ball

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Wstępna wycena dla PETG

2,02 € – 2,47 € netto (bez VAT)

Dla pliku: naipo_massager_replacement_spring_ball-PrusaSlicer_0.6n_0.25mm_PETG_MK4S_1h43m.bgcode

To wstępna wycena jednego pliku. Dokładną cenę poznasz przed zamówieniem.

Plik i założenia wyceny

Plik użyty do wyceny

Średnia wycena orientacyjna: 2,24 € netto (środek widełek).

Masa podana przez autora
42 g
Czas druku podany przez autora
1,71 godz.
Materiał u źródła
PET
Materiał wyceny
PETG
Drukarka wyceny
Bambu Lab P1S - 0.4 nozzle
Proces wyceny
0.20mm Standard

Orientacyjna wycena wyłącznie wybranego pliku, oparta na masie i czasie druku podanych przez autora. Warianty plików nie są sumowane. Ostateczna cena zostanie obliczona po analizie pliku.

Zapisane na tym urządzeniu.

Replacement massage ball/cup including spring for the Naipo electrical massager. (The screw on ball/cup part)

Ocena
0 / 5
Polubienia
1
Pobrania
9
Wydruki
0
Wyświetlenia
105
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

Naipo Massager Repair Story

If you have one of these electric massagers (they were very cheap a while ago and aren't all that bad), sooner or later you will run into the issue of some their internal parts becoming brittle and breaking.

Specifically these, which act as a kind of spring, providing extra pressure.

 

Well, the massager kind of works without them, yet much better with them. 

So I designed a replacement anyway ;-P   Enjoy!

 

 

Printing

use the ready-made Files for PrusaSlicer and BambuStudio or these settings:

 

  • prints fine with 0.4mm or 0.6mm nozzle
  • prints fine with 0.25mm layer height
    • (tested with 0.20mm to 0.30mm and variable layer height).
  • PETG for flexibility (i used cheap eSUN PETG-lite, which was very runny but has a nice flexibility to it and bends easily)
  • infill: 15% honeycomb
  • wall strength: 4 perimeters on 0.6mm nozzle or more when using 0.4mm.
  • supports: yes, organic/tree, critical regions only, build plate only
  • brim: I needed it, because the cheap filament was oozing a lot

Assembly

  1. print
  2. remove old part, keep the screws
  3. remove silicon dampener cuboid from old part
  4. put silicon dampener cuboid into printed part
  5. sand down the sphere, so it does not destroy the fabric when pressed against it
  6. screw in the replacement part.

Don't forget the silicon cuboid

 

Screw part in like this

 

License

  • CC-By-Sa
  • Share as you like, but always with attribution and link
  • Remix as you like, but always with attribution and link

 

Tagi