Naipo Massager Replacement Ball
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Replacement massage ball/cup including spring for the Naipo electrical massager. (The screw on ball/cup part)
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 9
- Makes
- 0
- Views
- 103
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Home Medical Tools
- License
- Creative Commons — Attribution — Share Alike
Naipo Massager Repair Story
If you have one of these electric massagers (they were very cheap a while ago and aren't all that bad), sooner or later you will run into the issue of some their internal parts becoming brittle and breaking.

Specifically these, which act as a kind of spring, providing extra pressure.
![]() | ![]() |
Well, the massager kind of works without them, yet much better with them.
So I designed a replacement anyway ;-P Enjoy!

Printing
use the ready-made Files for PrusaSlicer and BambuStudio or these settings:
- prints fine with 0.4mm or 0.6mm nozzle
- prints fine with 0.25mm layer height
- (tested with 0.20mm to 0.30mm and variable layer height).
- PETG for flexibility (i used cheap eSUN PETG-lite, which was very runny but has a nice flexibility to it and bends easily)
- infill: 15% honeycomb
- wall strength: 4 perimeters on 0.6mm nozzle or more when using 0.4mm.
- supports: yes, organic/tree, critical regions only, build plate only
- brim: I needed it, because the cheap filament was oozing a lot
Assembly
- remove old part, keep the screws
- remove silicon dampener cuboid from old part
- put silicon dampener cuboid into printed part
- sand down the sphere, so it does not destroy the fabric when pressed against it
- screw in the replacement part.
![]() Don't forget the silicon cuboid
| ![]() Screw part in like this
|
License
- CC-By-Sa
- Share as you like, but always with attribution and link
- Remix as you like, but always with attribution and link



