Galileo 2 G2E Umbilical Mount

After finally installing my G2E extruder I discovered that it crashed into the rear motors.

I have just deigned a new slimmer version here- 

 - that clears the motors and allow full use of the print surface. I'll leave this up but I do suggest using the new one in the above link.

================================================================================

Old below here…

This is a remixed Galileo 2 G2E PUG Umbilical Mount that uses a piano wire to support the umbilical cable. 

I used the same manner to mount the umbilical cable on my Stealthburner https://www.printables.com/model/1280344-umbilical-canbus-cable-bridge-mounts-for-stealthbu and now that I'm converting the extruder over to a G2E I want the same mounting method.

I'm also including a link to the rear cabinet cable mount:  https://www.printables.com/model/1315371-voron-trident-rear-cabinet-cable-mount 

There are two bodies. One should work with a 0.64mm rod and another for a 1mm rod. 

Some small zip/cable ties to fix the umbilical and a dab or two of thick CA glue where the piano wire passes through the mount are all you need. I'm using 0.64mm piano wire. I did use the two standoffs from https://www.printables.com/model/825175-galileo-2-g2e-pug-umbilical-mount/remixes to support the umbilical bracket.  

You may also be interested in my other Voron Trident mods shown here or at https://www.printables.com/@JimChristian_3198049  &  https://www.printables.com/@JimChristian_3198049/models  They work well  :-)

Also, if you find value in this, please give it a like. Thanks.