RAMA | Dishsoap and sponge holder for kitchen rail

RAMA | Dishsoap and sponge holder for kitchen rail

This is the dishsoap and sponge holder, part of the RAMA collection of kitchen rail accessories. 
You can fit 2 soap or dishsoap dispensers with a diameter up to Ø90mm. 
The sponge can rest and dry on the little protruding shelf, to keep your kitchen counter tidy and clutter-free.

The collection includes:

• a FREE set of wall brackets for Ø18mm or 3/4inch wooden rails, plus hanging planters and hooks.

And the following accessories:

• a marackgnetic knife 
• a cookbook or ipad shelf
• a dishsoap and spong holder
• a drip tray to dry your cutlery
• a spice rack
• a towel holder

3D PRINT SETTINGS: 
All STL files are all already oriented properly. 
No need for supports, or brim.

The hangers print on their side and don't need support, even for the overhanging part.

For the hangers, you can pick between 2 lengths: 245 or 280mm. 
I find that the longer the more convenient, but go with whatever fits on your print bed.

The bottom plate of the rack will appear "full", this is not a mistake. 
You need to turn it into a "mesh" by selecting an infill pattern of your choice, and setting the top and bottom layers to 0. 
On the example on the pictures, I used a 20% honeycomb infill.

Layer height: 0.2mm/layer 
Wall line count: 3 
Top layers: 0 (to cancel top face) 
Bottom layers: 0 (to cancel bottom face) 
Infill: 15 to 20% (honeycomb on the pictures) 
Build adhesion type: None 
Supports: None