Eachine EV800DM Screw-On Button & SMA protector
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Prevent accidental power-up of your EV800DM and protect your SMA ports at the same time!
- Ocena
- 5 / 5
- Polubienia
- 0
- Pobrania
- 20
- Wydruki
- 1
- Wyświetlenia
- 115
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Share Alike
This performs two tasks:
- Protect your Eachine EV800DM goggles from accidentally turning on in your bag because something pressed the power button.
- Protect your SMA Antenna connectors from dust, debris & deformation.
This is a simple .4mm nozzle print-in-place model which includes thumb-screws, because the needed imperial screw-cap is not something I have just at home as a European. I added some spacing at the base between the screws and the frame and some elephant foot compensation so it would not weld in the first layer.
For me on both test prints one of the screws was not cut properly when screwed in for the first time. I forced it on with a pair of pliers and after that it ran smooth without any damage to my SMA connector, I guess it might need some tapping if you have the 5/16" (??) tap bit, but forcing it on once does the job as well.
After that it can be screwed by hand, just don't overdo it.
It prints fine without support. The slicer added mouse ear brims to the ends, so it's probably a good idea to keep them. Other than that I just bumped up the walls&infill percentages and printed with concentric top&bottom layers inside-out. Use any stiff material you like. I used PLA.
Note: This apparently only works for the EV800DM. The EV800D appears to be 12mm narrower. There is a Remix attached to this model for that. Thanks, @bruchsturm, for that!