ESRack - Medium Bracket with Single Keystone

I really liked the original ESRack system design created by @EvilProphet. 

I created a Mounting Bracket medium for a single keystone connector.  This way you can use a Module to hold your modem our router with connections on the back and then route the ethernet cable to the front nicely for a patch cable. 

The ESRack system includes the following components:

• Mounting Brackets - used to install the unit in the rack, available in 3 sizes:
  • Short
  • Medium
  • Long
• Device Modules - each module can handle a single device

Possible Configurations:
- [Mounting Bracket Short] + [Module] + [Module] + [Mounting Bracket Short]
- [Mounting Bracket Medium] + [Module] + [Mounting Bracket Medium]
- [Mounting Bracket Short] + [Module] + [Mounting Bracket Long]
- [Mounting Bracket Long] + [Module] + [Mounting Bracket Short]
- [Mounting Bracket Long] + [Mounting Bracket Long] (Blank Front Plate)

All modules were designed with very little clearance so installation of some devices may need to be pushed in by force.
Before you start printing the system, print the Connecting Block to ensure that you can connect the modules.

All parts of the original creator @EvilProphet ESRack system can be found here.

Assembling

To connect the each individual modules together, you need:
- 4x M4 nuts (DIN934M4)
- 4x M4x12 allen screws (DIN912M4x12-8.8)

Use standard rack screws and nuts for rack mounting.

Suggested Print Settings
Material: PETG (Prusament PETG Galaxy Black)
Nozzle: 0.4 mm
Layer height: 0.2 mm
Wall loops: 3
Top/Bottom shell layers: 3
Infill: +25%
Infill pattern: Gyroid
Orientation: Print on the front surface