1 / 3
X-Shot Longshot FAMAS Carry Handle V2 — zdjęcie 1
1 / 3

X-Shot Longshot FAMAS Carry Handle V2

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

I've optimized my old design to address some issues.

Ocena
5 / 5
Polubienia
38
Pobrania
105
Wydruki
1
Wyświetlenia
911
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Outdoor Toys
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

After improving the internals of my XSLS, I took a look at my old carry handle and wanted to make some improvements. 

  • Lowered the carry handle significantly so you can now use a sight. Still, lower profile the sight, the better. 
  • More robust mounting on the blaster using Chance's 2 degree riser. I also used his picatinny rail for better printing orientation.
  • Smoothed out the edges of the model for a better finish.
  • Split into multiple parts for smaller beds, stronger print orientations, no overhangs, & fun bed surface textures.

Print Settings

5 walls, 20% infill. 

To mitigate sheering, using your slicer, add a triangular 100% infill modifier to cover the mount and going into the body. Included a photo of the orientation.

Add supports around the hex nut holes.

Print 8 pegs.

Hardware

2x M5x30
2x M5 nuts

No glue required. It survived without glue and being used as a lender. However, if you plan to use it as an actual carry handle, consider adding glue to the peg holes.

Assembly

Print 8 pegs as they align everything together. You may need to tap in the pegs with a hammer. Add the picatinny rail after the rest of the other parts are together.

 

Note: For the spots where the peg holes are harder to tap in with a hammer, use some spare wood or spare prints. Just be sure to support the bottom of the part too.
 

Once the carry handle is where it needs to be, add the nuts & screws. This will clamp the carry handle onto the pic rail.

 

Tagi