1 / 9
Angled stand for TheMidiMaker Sparrow 5x100mm MIDI controller
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
50° angled stand for Sparrow 5x100mm MIDI controller with cable management holes. Screws into base with M3x8 bolts.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 91
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Audio
- Licencja
- Creative Commons — Attribution — Noncommercial
An angled stand for the Sparrow 5x100mm MIDI controller.
Hardware
- The Midi Maker Sparrow 5x100mm MIDI controller
- 4 M3x8 bolts
Features
- 50° angle
- Designed to match Stream Deck+ and Stream Deck XL angle
- The stand is angled at 45°. The device comes with a built-in 5° angle. The resulting total angle is 50°.
- Screws into base of device with 4 M3x8 bolts
- Might work with the included screws but I did not test it
- Cable management
- A covered back with a cable management hole
- Two cutouts to pass cables through the left or right side of the base of the stand
- A hole in the base to allow managing cables without unscrewing stand
Suggestions
- Put rubber feet or magnets on the bottom
- Works best with a right angle adapter for the power cord