Audio Technica ATH-M30x M50x Headband
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
3D printable headband replacement for the ATH-M30x and others in the family (M50x)
- Ocena
- 0 / 5
- Polubienia
- 23
- Pobrania
- 78
- Wydruki
- 0
- Wyświetlenia
- 1740
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Audio
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I just wanted to make my M30x immortal so yeah
I tried printing this out of a bunch of different filaments but I found that PETG is the best material for it.
So far I tried random PLA+s, ABS+s and PETGs
Most PLA+ lasts around a month, ABS+ lasts just over a month (slightly longer than PLA+) and PETG has been going strong for 2 months so far.
Update: The v7 PETG band died at 10 months and the v8 should have fixed the stress concentration.
Update: The v8 PETG band died at 18 months and the v9 should further reduce the stress concentration.
Personally I added adhesive backed foam and wrapped the band with a section of black denim
So print in PETG with no supports
Non-Printed Hardware:
Requires 2x M3 ~10mm screws, 2x M3 Nuts, and 2x M3 ~9mm Washers