Micro Tricopter (Sub-250g)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Designed this to try and 3D print a sub-250g tricopter (Transport Canada Reg.)
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 56
- Wydruki
- 0
- Wyświetlenia
- 817
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Printed in PLA with 2 shells, and ~10% infill at 215C
(Slicer settings will need tweaking for optimal strength)
Non-printed parts list (Some parts may be substituted):
8 M3 Nylon Nuts
4 M3x16mm Screws
3 Brotherhobby Returner R3 1106
3+ Compatible Propellers
MG90S Servo
3 ~6A ESC
Aikon F4 Flight Controller
30x30mm Mounting Hole Power Distribution Board
Female XT30 Connector
Some ~22 Gauge Wires
Some ~18 Gauge Wires
~850mAh 3Cell LiPo
Compatible transmitter/receiver for your remote
Small ~10cm Zipties
Some notes on assembly:
The servo horn will need to be trimmed and CA glued to the rear motor mount
(The servo horn screw is still acessable)
I cut the servo wire and used the header to mount the transmitter/receiver
My Assembled Weight: 168.9g (My vary based on a lot of factors)
Message or comment any (hardware) questions you have
The tethered test flight was sketchy software and control-wise but the frame held up.
Note:
Betaflight doesn't like me or my weird servo setup.
Any help regarding getting betaflight to play nice would be appreciated