1 / 3
iPhone Lightning Cable Charging Dock
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple robust charging dock, designed to repurpose an old iPhone cable, into something new and useful.
- Ocena
- 5 / 5
- Polubienia
- 4
- Pobrania
- 28
- Wydruki
- 0
- Wyświetlenia
- 216
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
iPhone Desktop Charging Dock
This design repurposes your old iPhone lightning cable, as the charging unit for this docking station print.
Print settings
- 10% Gyroid infill
- 3 parameters “walls”
- Enable outer brim
- Enable “Detect Thin Walls”
- No support needed
Guide (Quick)
- Print the docking station file
- Insert you lightning cable from the back, through the hole, and pull it into place, it should fit precisely.
IMPORTANT !
I designed this to fit an iPhone with a cover on, but if you want to use this docking station with a good fit still, but without a phone cover, then follow these steps:
This requires replacing the plastic housing on your cable, but it is a simple fix and wont damage your cable if done correctly.
- Download and print the “Cable_Housing_Replacement.stl” file
- Remove the original plastic housing on your cables connector end.
- Slide the replacement housing that you printed on the connector, until it alligns like the original did.
- Dap a tiny amount of super glue inside the housing, from the cable end only NOT the connector end, this will secure the new housing.
- Done, now just follow (Guide (Quick) - Step 2).