Fractal-Design Mood Case Fan Noise Killers
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple fix for a real annoying issue.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 22
- Wydruki
- 0
- Wyświetlenia
- 580
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I picked up a Fractal-Design Mood case despite the review from Steve at Gamers Nexus, but after assembling the machine, I noticed, no matter what speed the fans were running at, cover on = 10x louder, remove the lid and fans are almost silent.
Its not just the fabric on this case causing the excessive noise, its the fabric and the little holes in the casing and the fans being to close cause all the noise, pulling the fans back about 20mm makes them sound almost normal.
So I designed these 25mm fan spacers, they are designed for 140mm fans, and I'm running the Artic Pro Max high speed fans, these can be a little loud at full noise, but until I did this mod, I had them running at 600rpm max as the noise generated from the fan blades chopping past the case on the inside was awful.
They are dead simple to use, they are threaded already, just use some M3 SHS with washers, 30 to 35mm for the fan and 6 to 10mm for the bolting the spacer to the mounting bracket.
I made them with minimal material, 2 to 3 walls and 25% is more than enough, mine are done in PETG-GF, but I'm sure PLA will be just fine.