Wall Hooks For Big Paintings (UPDATED)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Heavy-duty wall hooks safely support large, heavy paintings. Choose the right anchor for your wall type for maximum stab
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 60
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Wall-mounted
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
🖼 Wall Hooks for Big Paintings (UPDATED)
Upgrade your home gallery setup with these heavy-duty, low-profile wall mounting hooks! Designed for stability and practical installation, this bracket provides a sturdy mounting point for framed artwork, canvas prints, and oversized wall decor.
📑 Table of Contents
Section | Description |
|---|---|
Design purpose and introduction | |
Main design benefits | |
Dimensions and material details | |
Recommended slicer settings | |
Mounting instructions | |
Important load and safety considerations |
🌟 1. Overview
Finding reliable mounting hardware for large artwork can be challenging. This bracket features a reinforced support structure designed to distribute loads while maintaining a clean, minimalist appearance.
Whether you're setting up a home gallery or hanging decorative pieces, this 3D-printable design offers a practical DIY mounting solution.
✨ 2. Key Features
💪 Reinforced Structure: Features a wide load-bearing flange and a reinforced support spine designed to improve structural stability.
🔩 Flush-Mount Countersunk Holes: Includes two countersunk screw holes with a 4 mm diameter for a neat installation.
🎯 3D-Printing Friendly: Designed to print flat on the build plate without requiring support material.
🎨 Minimalist Design: A clean, compact profile intended to remain discreet behind or alongside mounted artwork.
📐 3. Technical Specifications
📏 Overall Base Footprint: 35 × 75 mm
🕳 Screw Hole Diameter: 4 mm, countersunk
🧵 Original Material: White PLA
📊 Recommended Layer Height: 0.2 mm
🧱 Recommended Infill: 50% or higher
🧩 Recommended Infill Patterns: Gyroid or Grid
🖨 Supports: Not required in the intended orientation
🖨 4. Print Settings & Recommendations
Filament Material: PLA, PETG, or Tough PLA
Layer Height: 0.2 mm
Wall Loops: 4–5 walls
Infill Density: 50% or higher
Infill Pattern: Gyroid or Grid
Supports: Disabled
Print Orientation: Place the model flat on the build plate as designed
Note: These are recommended settings, not verified load ratings. Actual strength depends on filament quality, print orientation, layer adhesion, and mounting conditions.
🛠 5. Installation Guide
📍 Choose the Mounting Location: Position the bracket at the desired height on a suitable mounting surface.
🧰 Secure the Bracket: Use compatible 4 mm countersunk screws and appropriate anchors or fasteners for the wall material.
🔩 Check the Fit: Ensure the screw heads sit flush and the bracket is firmly attached.
🖼 Mount Your Artwork: Carefully position the frame or artwork and check that it is stable.
⚠ 6. Safety Notice
The maximum safe load of this 3D-printed component has not been established. Do not assume it is suitable for heavy or valuable artwork without testing the complete mounting system. For heavy frames, use appropriately rated commercial hardware secured to suitable structural supports.
Enjoy the design! If you print this model, share your make and feedback to help improve future versions.