Fabric Drawer stopper clip
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Stop fabric drawers from falling out when pulling them out too far. Simply slides in place, held with friction.
- Ocena
- 5 / 5
- Polubienia
- 1
- Pobrania
- 13
- Wydruki
- 1
- Wyświetlenia
- 164
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution
I had a problem where my nephew kept pulling these drawers out, so I made a solution.
These simply slide onto the side of the fabric boxes and are held by friction. I had to make 2 variants for my drawers, the original design that has a 30mm depth for all but one drawer and a 40mm depth variant for the top as the original design collided with a screw head.
You are still able to remove the drawers without taking the stoppers off, just by bending one of the sides of the drawers while pulling them out.
I used a 3% gyroid infill, 0.4mm nozzle, 0.26mm layer height and 0.44 extrusion width with Amazon Basics PLA on a CR-10 Max. Each clip weighs around 3g and is quite strong.
This is my first design, so go easy on me.