Kill switch for 1982 Yamaha XT 550 dirt bike
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Kill switch for 1982 Yamaha XT 550 dirt bike
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 182
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution
The kill switch on the 1982 Yamaha XT 550 dirt bike has a weak point in the switch. Instead of buying a whole new kill switch module, the switch itself can be easily replaced. I modeled the part after the original piece. I printed out of PETG and my BIL says it works great. Uploading the stl, step, and freecad versions in case anybody wants to get more fancy with it than I did.
I printed the model on its side. BIL said he had to dremel off a bit of the support material to allow the lever part to pass through the casing, but the nominal dimension should be spot on. This model requires the reuse of the rubber stopper, spring, and contact plate original to the design, though with a bit of resourcefulness I'm sure one could come up with a way to replace those as well.
Note: The last image does show a crappy overhang surface. I think this was a first iteration. I dialed in the slicing settings for the subsequent prints but I recognize that one is garbage. I just failed to get better pictures of the finished product.