Oval Over Lid Chapstick Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Made larger, and reduced overhang from the original by MyWay2Build
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 56
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution
Adjustments to the original include added geometry to hopefully eliminate overhang and widening and lengthening to fit over the cap.
I don't trust myself enough to believe my print would be air tight enough to keep the stick moist, so I made it so the original cap would pressure fit into the lid, you COULD glue it, but I don't believe that that's necessary.
Included is the non-scaled one in the instance that your prints are trusted enough, but want a little less overhang.
Printed at 0.2mm layer height, PETG, normal speed, support on plate only. Printer was an Anycubic Kobra S1.
I did not design this in any capacity. Please make all attributions to MyWay2Build.