Oval Over Lid Chapstick Holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Made larger, and reduced overhang from the original by MyWay2Build
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 9
- Makes
- 0
- Views
- 57
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Office
- License
- Creative Commons — Attribution
Adjustments to the original include added geometry to hopefully eliminate overhang and widening and lengthening to fit over the cap.
I don't trust myself enough to believe my print would be air tight enough to keep the stick moist, so I made it so the original cap would pressure fit into the lid, you COULD glue it, but I don't believe that that's necessary.
Included is the non-scaled one in the instance that your prints are trusted enough, but want a little less overhang.
Printed at 0.2mm layer height, PETG, normal speed, support on plate only. Printer was an Anycubic Kobra S1.
I did not design this in any capacity. Please make all attributions to MyWay2Build.