SV08 Minimal toolhead cover with HeroMe ducting
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a mod of the Minimal Toolhead cover for the SV08, but with the ducting from the HeroMe for improved cooling
- Ocena
- 4,778 / 5
- Polubienia
- 36
- Pobrania
- 173
- Wydruki
- 10
- Wyświetlenia
- 984
- Oceny
- 9
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
UPDATED: 2026-01-05 the V3 models below are the good ones... I have greatly improved the airflow and printability of the model. It is now possible to print with the front face at a 45 degreee angle to the build plate, which greatly improves the strength of the support clips, and after extensive testing, the airflow is much better... I will upload pictures once I have printed one that isn't my ugly test version... I also have a new fan test STL, based on part of benchy:
I really liked the minimal toolhead cover for the SV08, but wasn't happy with the airflow I was getting for part cooling. As I am the designed of the cooling ducts for the HeroMe, I (with the help of Andy, the HeroMe head honcho ) replaced the ductwork with a version of the HeroMe ducts. This required updating my CFD models of the duct, but it seems to have come out fairly well. This still uses the stock fan, although I have removed the second fan from the back as it no longer seems necessary. I print this with no supports, with the flat front against the bed. I personally use PCTG filament, although you might want to go with something higher temperature…
I have updated the models, there is now a cutout to allow use with the Rappetor low BTT eddy mount https://www.printables.com/model/968900-sovol-sv08-btt-eddy-mount, and there is a version for both a 3mm and a 4mm thick magnet.
I have also done comparision prints using the Teaching tech cooling torture test https://www.printables.com/model/180150-cooling-fan-test-torture-test, which showed significant improvements.
First, the stock cover with both fans with stock Orcaslicer cooling settings:

Next, My cover and duct, with no rear fan and stock cooling settings:

And finally, mine again, with the fan power pinned to 20%:

My best theory as to why the bridging is better at 20% is that the force of the air from the fan is stretching the bridge filament. If I reduce it below about 20% the results are truly terrible, though.
