1 / 8
SV08 Minimal toolhead cover with HeroMe ducting — image 1
1 / 8

SV08 Minimal toolhead cover with HeroMe ducting

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

This is a mod of the Minimal Toolhead cover for the SV08, but with the ducting from the HeroMe for improved cooling

Rating
4.778 / 5
Likes
36
Downloads
174
Makes
10
Views
991
Reviews
9

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

UPDATED: 2026-01-05 the V3 models below are the good ones... I have greatly improved the airflow and printability of the model. It is now possible to print with the front face at a 45 degreee angle to the build plate, which greatly improves the strength of the support clips, and after extensive testing, the airflow is much better... I will upload pictures once I have printed one that isn't my ugly test version... I also have a new fan test STL, based on part of benchy: 

I really liked the minimal toolhead cover for the SV08, but wasn't happy with the airflow I was getting for part cooling. As I am the designed of the cooling ducts for the HeroMe, I (with the help of Andy, the HeroMe head honcho ) replaced the ductwork with a version of the HeroMe ducts. This required updating my CFD models of the duct, but it seems to have come out fairly well. This still uses the stock fan, although I have removed the second fan from the back as it no longer seems necessary. I print this with no supports, with the flat front against the bed. I personally use PCTG filament, although you might want to go with something higher temperature…

I have updated the models, there is now a cutout to allow use with the Rappetor low BTT eddy mount https://www.printables.com/model/968900-sovol-sv08-btt-eddy-mount,  and there is a version for both a 3mm and a 4mm thick magnet.

I have also done comparision prints using the Teaching tech cooling torture test https://www.printables.com/model/180150-cooling-fan-test-torture-test, which showed significant improvements. 

First, the stock cover with both fans with stock Orcaslicer cooling settings: 

 

Next, My cover and duct, with no rear fan and stock cooling settings:

 

And finally, mine again, with the fan  power pinned to 20%:

 

My best theory as to why the bridging is better at 20% is that the force of the air from the fan is stretching the bridge filament. If I reduce it below about 20% the results are truly terrible, though.

Tags