Simple Lightweight Centauri Carbon Riser

I wasn't happy with the available risers so I made yet another. This comes out to about 160g in around 4 hours (other solutions are at about 300g).

Though it may not look like it, this is pretty sturdy. You can rattle the whole printer when grabbing onto the lid handle while the “vent” is open and the lid stays in place.
 

Assembly
Note: you should do a dry fit before glueing the riser.

To assemble the parts, put some glue on the inner mating surface as shown in the last picture. Do not put glue all the way down. Put the four parts of the riser onto the printer.

Put some paper towels onto the spots you glued and the lid on top. I recommend weighing the lid with two rolls of filament while it dries. The towels are to prevent the glue as well as its fumes reaching the lid.

Wait for the glue to dry and remove the towels. If you want, you can remove the riser and put some glue on the bottom.
 

Remixes
I'd love to see what you can come up with, so I attached the CAD file. A better way to attach the pieces, maybe with a print-pause nut you can screw into from the side, would be nice, but I dont have the time to do that. Have fun!