Sofle RGB plus tps43 enclosed case remix
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix of the ErgomechStore's enclosed case with space for a right side tps touch module from holykeebs
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 56
- Wydruki
- 0
- Wyświetlenia
- 523
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Public Domain
If you are not using the tps module, mirroring the left side should work fine. Same if you are using the tps module on the left side.
Printed with the top of the case facing down the plate, supports for the tps cut and some of the holes (those are not really necessary), using PLA.
The 1.5u key is a little tight on the bottom, depending on how your bottom plate is closing it may catch a little, so it may require some little sanding just to make sure it doesn't touch anything. Of course, that depends on your printer having the correct tuning for dimensions, tolerances are a little tight.
Hardware:
You will need 7 M2 screws for the bottom plate. I used self tapping ones but if you're fancy you can probably add heat inserts there.
Lowriding variant
I did a quick and dirty cutting and lowering of the OLED area. If you are using super low profile headers or similar you may be able to use it and make the oled display show up more. The first version had the display kinda set way down and hard to see. You will need to use some small screws (I used M2x4 self tapping screws). The screws show up, but they are fine IMO.
It's super janky and untested! Use at your own risk.
The tps module can be found at holykeebs.